Cisco WRV210 problem port forwarding POLAND

[t.cichowicz]

Witam

Urzadzenie nie chce przyjac ustawien przekierowania portow, router zglasza sie adresem MAC 00:00:00:00:00:05.

-----

Device dont change port forwarding settings, router have mac address 00:00:00:00:00:05. Device not working properly.

[Tom Watts]

Jesli nie mozesz zastosowac ustawien z WEB UI sprobuj innej  przegladarki internetowej jak Firefox, Chrome, itd. Mozesz rowniez  sprobowac starszej wersji IE7 albo IE8, lub IE9 z opcja zgodnosci przegladnia.

Jesli to nie dziala zaktualizuj router do nowej wersji software 2.0.1.5 i przywroc ustawienia  fabryczne wciskajac przycisk reset przez 35-40 sekund.

If settings do not apply from the WEB UI, try a different  browser such as Firefox, Chrome, etc. You may also try older IE 7 or 8  or IE 9 in a compatibility view.

If it still does not  apply setting for the port forwarding, give the router a firmware  upgrade to the 2.0.1.5 and factory reset the unit holding the reset  button for 35-40 seconds.

-Tom

[t.cichowicz]

Thanks Thomas. I use Firefox, Opera, Chrome and IE8 but some part of web gui dont work(example

http://192.168.103.1/SetupPPPoE.asp a have empty white screen)

. I have firmware 2.0.1.5 and this firmware was installed 3 times, when device not working properly. This is strange device, I must every mont reinstall firmware in device, this behavior is not normal.

[Tom Watts]

Most of the time when the web UI does not display correctly, it is an issue with the computer accessing the device. Very, very seldom it is the router.

Try a different computer and see if it yields a result. The router UI use Java and the way computers handle Java are different for whatever reason. The WRV210 is a bit of an older router also, new operating system / security patches sometimes affect how the html loads within the UI for the older products.

-Tom