cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
181
Views
0
Helpful
2
Replies
Highlighted
Beginner

Configure SSL VPN on RV340

Hello All,

 

I am new in this community. I have a Cisco RV340 with a software version 1.0.03.15 at our office location. I am trying to configure an SSL VPN following the steps in the link below. However,  I have a couple of questions:

 

https://www.cisco.com/c/en/us/support/docs/smb/routers/cisco-rv-series-small-business-routers/smb5553-configure-anyconnect-virtual-private-network-vpn-connectivit.html?referring_site=RE&pos=3&page=https://www.cisco.com/c/en/us/support/docs/smb/router...

 

 

  • What is the address pool IP address I have to use?

 

SSL VPN gateway settings.png

 

  • Do I need to have a static IP address from my ISP for the WAN1 port?
  • If I need a static IP address in place of that, can I configure a DynDNS?
  • If I don't need either, which IP address should I use on the Cisco AnyConnect secure mobility client?

I would appreciate your support in these questions. 

 

Regards

 

 

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Cisco Employee

Hello,

 

Please first upgrade the firmware to 1.0.03.20 (https://software.cisco.com/download/home/286287791/type/282465789/release/1.0.03.20)  

 

1. Those IP addresses will be allocated to your remote VPN clients so it can be any pool different from the RV internal IP addresses (VLANs).

2. It is recommended to have and therefore use a static public IP address on the WAN which acts as VPN gateway.

3. Typically DynDNS is a method used for keeping a domain name linked to a changing IP address so that DynDNS assigns a fixed domain name to a dynamic WAN IP address. In your case with static WAN IP address, there is no need for using DDNS. 

4. On Cisco AnyConnect Secure Mobility Client you enter the RV WAN IP address/port to connect through the SSL VPN.

 

Regards,

Martin

 

View solution in original post

2 REPLIES 2
Highlighted
Cisco Employee

Hello,

 

Please first upgrade the firmware to 1.0.03.20 (https://software.cisco.com/download/home/286287791/type/282465789/release/1.0.03.20)  

 

1. Those IP addresses will be allocated to your remote VPN clients so it can be any pool different from the RV internal IP addresses (VLANs).

2. It is recommended to have and therefore use a static public IP address on the WAN which acts as VPN gateway.

3. Typically DynDNS is a method used for keeping a domain name linked to a changing IP address so that DynDNS assigns a fixed domain name to a dynamic WAN IP address. In your case with static WAN IP address, there is no need for using DDNS. 

4. On Cisco AnyConnect Secure Mobility Client you enter the RV WAN IP address/port to connect through the SSL VPN.

 

Regards,

Martin

 

View solution in original post

Highlighted

Hello Martin,

Thank you for the prompt reply. 

 

I will acquire the static public IP and proceed with that. I will feed the community back on the results. 

 

Thank you again.