Configuring RDP Access with an RV042

[cjbuie358]

Hello,

I am trying to allow RDP access to my server through my RV042.

I added an access rule:

Action: Allow

Service: RDP [3389]

Source Interface: WAN1

Source: Any

Destination: 192.168.2.10

Time: Always

192.168.2.10 being the internal IP address of my server.

But, when I try to RDP in, I cannot connect.

Any suggestions as to what I am doing wrong?

Many thanks,

Chris

[jurodri3]

Hello Mr. Buie,

Please check that on the firewall options you have the next configuration

Block Wan Request: Disable.

Remote Management: Enable.

Diego Rodriguez

Cisco network engineer

Thank you

*If this answer was satisfactory for you, please mark the question as Answered.*

[cjbuie358]

Block WAN Request was enabled ... I changed that to disable.

Remote Management was already enabled.

Unfortunately, still unable to connect.

[jonatrod]

Hi Christopher, to add to Juan's post, did you create a port-forwarding rule?

If you want redirect the RDP service to a specific ip, you have to create this rule.

In order to do this, follow these instruction:

1. Go Firewall>Access rule

2. Click on Service Management> and configure each space like this.

Service name : RDP

Protocol:TCP

Port Range: 3389   to:  3389

Add to list > Save Settings > Exit

3. Configure each space like this

Action:Allow

Service: RDP [TCP/ 3389-3389]

Source IP:any

Destination IP: 192.168.2.10

4. Save settings

I hope you find this answer useful, if it was satisfactory  for you, please mark the question as Answered.

Please rate post you consider useful.

Greetings,

Johnnatan Rodriguez Miranda.

Cisco network support engineer.