cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.
Get the latest news in this issue of the Cisco Small Business Monthly Newsletter

493
Views
0
Helpful
1
Replies
Highlighted
Beginner

Console via aux port on Cisco891F Router

Hi,

I am trying to console to another router connected via a aux port. Following is my setup

R1(aux port)------------>R2(console port)

--------------------------------------------------------------------------

On R1

following is the aux port configs

line aux 0
 modem InOut
 no exec
 transport preferred telnet
 transport input all
 transport output all

interface Loopback1
ip address 1.1.1.1 255.255.255.255

sho line output

 Tty Typ     Tx/Rx    A Modem  Roty AccO AccI   Uses   Noise  Overruns   Int
      0 CTY              -    -      -    -    -      0      30     0/1554    -
*     1 AUX      0/0     - inout     -    -    -      1       0     0/0       -
      3 TTY              - inout     -    -    -      0       0     0/0       -

--------------------------------------------------------------------------------------------------------

i try to telnet into R2 on loopback1 address port 2001

Following is the result

R1#telnet 1.1.1.1 2001
Trying 1.1.1.1, 2001 ...
% Connection refused by remote host

Please check to see if i have missed anything.

i also note that the console port is also the aux port on Cisco891F

1 REPLY 1
Highlighted
Hall of Fame Community Legend

Duplicate thread. 

Duplicate thread. 

Original thread found HERE.