cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
545
Views
0
Helpful
0
Replies

Firewall on RV130W with DMZ Host enable

Tomasz Bres
Level 1
Level 1

Hello

I've configured DMZ Host on my RV130W Router. To allow internet access, I've add two Access Rules to allow HTTP and HTTPS traffic form Internet to DMZ.

So my Access Rules table looks like this:

I've checked logs on my DMZ hosts and was quite surprised. I had a lot of SSH and Telnet attempts dropped by firewall on my DMZ Host.

It turns out, that Access Rules doesn't matter and All traffic going form Internet to WAN port is redirected to DMZ HOST!

I was trying to add Always Block on Any Traffic Rule as last rule in table, but it was affecting HTTP and HTTPS traffic as well.

How can I configure simple firewall ACL, that will permit HTTP and HTTPS traffic form WAN and will drop all other traffic?

Why in every ACL "deny any any" is standard, but not here?

0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: