11-12-2014 09:37 AM
Hi,
Im using vsftpd on a Linux Server and I need to forward a port range to this server (passive mode).
I can do it with any of the other routers I have but not with the RV220w.
I created a custom service with a start and finish range, but there is no place to enter a range under the Port Fowarding tab like I have with the other routers.
Im using the latest firmware by the way.
Any tips ?
Thank you
11-12-2014 10:22 AM
Hi ,
Can you try please to do Access rules instead of Port forwarding. under firewall --> access Rules
from WAN to LAN | always allow | Choose your service | Source = any | Dnat = Local IP server
Enable rule
Please let me know after your testing
Please rate this port or marked as answered to help other Cisco Customers
thanks
Mehdi
11-12-2014 10:37 AM
Hi,
I tried that already, I get "Disconnected from server: ECONNABORTED - Connection aborted" from my client (FileZilla).
The server runs perfectly in DMZ or behind the RV220w (local) btw.
I dont understand why Cisco has to make things so different. Even DD-WRT is more straightforward.
Thanks for your time btw.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: