cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.

465
Views
0
Helpful
2
Replies
albertldee
Beginner

help with rv082

i have the RV082 v03 i set it for load balancing i have 2 8gb Adsl modem connected to Wan1 and Wan2

Question how can i assign a certain pc to use the connecton on Wan2, what i would like is to assign a specific pc on the network to wan2 

2 REPLIES 2
Te-Kai Liu
Rising star

Look for the protocol binding settings under System Management>Dual WAN>Edit WAN2.

With a ptotocol binding rule, you can bind all traffic originating from a given IP address to WAN2.      

jurodri3
Beginner

Hello Alber Idee,

Let me share with you some information found on the guide me section about protocol biding configuration step by step.

I hope this information helps you.

http://sbkb.cisco.com/CiscoSB/ukp.aspx?vw=1&docid=69b1889ee61d42bb9a389bf69fb7bf28_Priority_Bandwidth_magement_using_Rv042.xml&pid=4&fcid=&fpid=&slnid=3

If this answer was satisfactory for you, please mark the question as Answered.

Diego Rodriguez

Cisco network engineer

Thank you