cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.

1847
Views
0
Helpful
3
Replies
tcianflone
Beginner

How to debrick a WRVS4400N V2 Router?

I've got a WRVS4400N V2 Router that just keeps rebooting itself. It powers up, the diag red LED stays lit, it gets part way through the boot process and reboots itself. I would like to try to reflash the device, but don't know if this is possible in the condition that it is in. Any ideas? Thanks!

3 REPLIES 3
jurodri3
Beginner

Hello Mr. Cianflone,

Usually the red led flashing indicates a hardware issue. In that case, I would recommend you a factory reset and if the problem persist. Please contact our Cisco support center and open a case.

http://www.cisco.com/en/US/support/tsd_cisco_small_business_support_center_contacts.html

Diego Rodriguez

Cisco network engineer

Thank you.

What is the procedure to perform a factory reset please? Thanks!

hold the reset button for 20 sec and then release it.