02-27-2021 07:57 PM
We are using rv130 to connect internet.
IPS offering internet connection via PPPOEv6 and IPV6 address.
WAN port can receive IPv4 and IPv6 address.
How can I config DHCPv6-pd ,so that on of my server on LAN can assign IPV6 address from ISP.
02-28-2021 12:53 AM
- Probably not supported the data sheet (https://www.cisco.com/c/en/us/products/collateral/routers/small-business-rv-series-routers/datasheet-c78-738909.html) , lists the following ipv6-features only :
IPv6 |
02-28-2021 02:56 AM
So. which product support DHCPv6-pd?
02-28-2021 03:34 AM
- My initial reply could be incorrect , have a look at this guide :
https://www.cisco.com/c/dam/en/us/td/docs/routers/csbr/rv130w/admin_guide/en/rv130w_admin_en.pdf
Look for 'Prefix Delegation' with find in your browser and view the concerned paragraphs completely. Check if this can provide more insights.
M.
02-28-2021 05:11 AM - edited 02-28-2021 05:15 AM
Oh, I found it.
Sadly. My ISP provide IPv6 after PPOE dialup. and the option only affects WAN connection type is DHCPv6 mode.
When I set IPv6 wan DHCPv6 mode and Prefix Delegation enabled. WAN port can not get IPv6 address from ISP.
When I set IPv6 wan mode PPOE IPv6, then WAN port can get IPv6 address from ISP. but router can not prefix delegation IPv6 addresses to LAN network.
I need is after PPOE dialup , WAN port be assigned from ISP, and prefix delegation to my LAN.
I can not do that both. I remember rv130 support it some years before.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: