I have a problem with my RV325 VPN WAN Router.

[ahmedsadany]

Hi there,

Hope this message finds you fine. I have a problem with my RV325 VPN WAN Router. I have four remote users connect through Cisco VPN client to the server. I did the setup of VPN and it worked fine, But it only allow 2 users to access my network. Only 2 and the Router supports 25 VPN user. How can I increase the number of tunnels connected to the Router.

And one more thing.. After along time of disconnecting the Client. Remote users cannot reconnect to with VPN unless I restart the Router. and then everything works fine. So, I have to restart the Router everyday so the remote users can reconnect to the server. 

- How to setup more tunnels to VPN ?

- How users can easily connect to VPN without the need to restart the Router?

Kindly find the attach files regards to the Print Screen Configuration.

Thanks in advance

[Thierry CLAUSS]

Hi

You write :
"After along time of disconnecting the Client. Remote users cannot reconnect to with VPN unless I restart the Router. and then everything works fine. So, I have to restart the Router everyday so the remote users can reconnect to the server"

Post your screenshot, the RV320 firmware is 1.3.1.10.
I have the same problem, I should restart my router every day.
The firmware did not appear stable,
I returned on a firmware 1.2.1.14, my VPN connections are functional again.

Cordially