Is there a way to create a IPSec VPN tunnel between my cisco rv082 and my iOS devises the reason for this is very simple I don't have access to enough pptp connections 5 is a bid low when you have use for 10+ mobile connections
Solved! Go to Solution.
Thank you for reaching Small Business Support Community.
As per the RV082 datasheet you can have up to 100 site to site tunnels. Regardless of the operating system both devices must use a common key or certificate and must have the same security policies set up. Please refer to the admin guide, appendix D, for a detailed configuration instruction;
Please do not hesitate to reach me back if there is any further assistance I may help you with.
Jeffrey Rodriguez S. .:|:.:|:.
Cisco Customer Support Engineer
*Please rate the Post so other will know when an answer has been found.
To create a tunnel in RV082, please refer the following articles:
I hope this information help you.
Unfortunaly I still get the same error on my iOS device when I try to setup a client to gateway connection with dynamic IP + email on remote client settings witch is the way I shall be setup for a iPhone the error I get is the generic "server dous not respond" error witch really don't tell me where the error is