ISR4331 - NAT issue %Port 22 is being used by system
I'm trying to add a dynamic and a static NAT on a ISR4331 device. The dynamic works fine but when I enter in the static I get the error "%Port 22 is being used by system". I cleared the ip nat trans*, remove dynamic NAT and added the static first and still get the same error
interface GigabitEthernet0/0/0 description Outside LAN Interface ip address 192.168.98.50 255.255.255.0
interface GigabitEthernet0/0/1 description Inside ip address 192.168.1.1 255.255.255.0
ip nat inside source route-map NAT-DYNAMIC-RMAP interface GigabitEthernet0/0/0 overload
Hi. We have been looking at using either the RV260P or RV345P as basically a "network in a box" type of solution for some of our small customers. The hope is we can use these devices when the customer has 8 or fewer VoIP phones rather than deploying a sma...
At Cisco, we’re helping small businesses implement technology innovations so they can find success while navigating a complex and hard-to-predict business landscape. Through our Small Business Recovery Kit contest, we’re also giving entrepreneurs the...
How do I configure a Windows VPN to a Cisco RV260W? Firmware 1.0.00.17 purchased June 2020 Tried PPTP many different ways and all I can ever receive is:"The remote connection was denied because the user name and password combination you provide...
Small businesses are facing the realities of the new normal and wondering how to best monitor, protect, manage and grow. Cisco understands the unique needs of small businesses and is committed to help overcome their top IT challenges.
Small business owners are dreamers. They have been brave enough to act on their dreams, going out on a limb to turn their bright ideas into reality. While the challenges and rewards of building a small business can be appealing, it is also difficult to s...