cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.

408
Views
0
Helpful
1
Replies
the eyed
Beginner

Method is unset but I can see IP address from (sh ip int br)

Hello
is there anyone to explain how this is possible?
I can see Ip address from " sh ip int br" but there is no configuration for this interface and method is unset
is it some kind of bug?
please see below information for your understanding
 
Router#sh ip int br
Interface              IP-Address      OK Method Status                Protocol
GigabitEthernet0/0/0   unassigned      YES NVRAM  up                    up
Gi0/0/0.XXX            1XX.XXX.XXX.XXX YES NVRAM  up                    up
GigabitEthernet0/0/1   unassigned      YES NVRAM  up                    up
GigabitEthernet0/0/2   unassigned      YES NVRAM  up                    up
GigabitEthernet0/0/3   unassigned      YES NVRAM  up                    up
GigabitEthernet0       unassigned      YES NVRAM  administratively down down
Loopback0              1XX.XXX.XXX.XXX YES NVRAM  up                    up
Port-channel10         unassigned      YES unset  up                    up
Port-channel10.XXX     1XX.XXX.XXX.XXX YES NVRAM  up                    up
Tunnel0                123.XXX.XXX.XXX  YES unset  up                    up
Router#sh run interface tunnel0
Building configuration...
Current configuration : 5 bytes
end
Router#sh run interface port-channel 10
Building configuration...
Current configuration : 145 bytes
!
interface Port-channel10
  no ip address
 no negotiation auto
end
1 REPLY 1
cmarva
Enthusiast

which interface do you mean?

if you mean po10, it won't show any config because there is a subinterface defined so you would have to do a sho run on that subinterace.