cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
307
Views
0
Helpful
0
Replies

need to have remote users access to site-to-site subnets

hi,

 

I am using 2 rv340 routers on my 2 wan sites. i have 2 networks connected via a site-to-site vpn. 192.168.0.0 and 192.168.6.0.

 

I also have a l2tp vpn setup for remote users. network is 192.168.10.0 (this vpn is setup on the router for 192.168.0.0 network)

 

When a remote user is connected to router (ip 192.168.0.11), it can see the 192.168.0.0 network but it cannot see the subnet 192.168.6.0. I have added 192.168.10.0 to the both routers site to site vpn entries, but still nothing.

 

I used the router debug packet capture using http://routerip/debug/packet_capture.html and i found out that the traffic from the 192.168.10.0 network is going towards my ISP static ip address (wan address) but the traffic from my 192168.0.0 network is going directly to 192.168.6.0 network (probably over the vpn).

Please help !!!

0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: