In order to be able to configure AVC you first need to go to the Tab of Security->Application Control and activate the feature, in this case because you are still under the evaluation mode is going to allow you to activate the feature, then enter the configuration desire and you can move on with the config of the AVC.
Thanks I created a test policy with no setting. It seems to be working. I am seeing an issue in application control statistics. I have a SG300-28 layer 3 switch in layer 3 mode feeding the RV340 router in a router VLAN using a 30 bit mask. The problem I am seeing is all the traffic out going is reported as coming from the layer 3 switch not the individual devices. So upload is not usable. Download works because it has the individual IP addresses which allows me to distinguish between devices by IP. Is there a way to fix the upload to show the individual devices and not the layer 3 switch?
Fix SPA500 Series SOS Mode Recovery
The SPA500 Series phone goes to SOS Mode Recovery state when the firmware on the phone is damaged. This is typically caused by abnormal operation such as a power interruption while the ph...
Replace the Default Self-Signed Certificate with a 3rd Party SSL Certificate on the RV34x Series Router
A digital certificate certifies the ownership of a public key by the named subject of the certificate. This allows ...
I was buy brand new router and have connected him to console port but when i need to hit enter after I get message press enter
.I push enter but it says: " authentication error"
I see there is some errors during startup in IOS row 1,5,6,7,8 is little str...
Cisco RV34s comes with pre-defined Microsoft Azure IPSec profile, but seems it's impossible to set up a tunnel with Azure just using default settings.
First, you can find messages in RV34x logs like follow:
charon: 11[NET] rec...
Firmware Downgrade Rules for Cisco Small Business Switches
Cisco Small Business switches sold with the latest release of firmware 2.4.0.x and greater use an updated chipset for Power over Ethernet (PoE) 6920xM version 0x4a0...