Problems connecting a WAP4410N to a WRVS4400N using WDS

[bjbukowski]

I have cinfigured both devices with the same SSID's, channels (6) and Security WPA2 and linked the two using site survey wireless MAC addresses. And can not connect to the repeater (WAP4410N) with any client. Searched all the treads here and tried all the suggestions. Clients can connect to the WRVS4400N with no issuses.

Unable to ping either device from the other.

If you need further info I would be glad to provide.

Thanks for your help

[jeffrrod]

Dear Brian,

Thank you for reaching Small Business Support Community.

Have you tried to enter the MAC address of the remote access point directly? I would also suggest you to try a different wireless security mode than WPA2 and make sure you are running the latest firmware release versions on both routers;

http://software.cisco.com/download/navigator.html?mdfid=282413304

Please let me know if there is anything I may assist you with in the meantime.

Kind regards,

Jeffrey Rodriguez S. .:|:.:|:.
Cisco Customer Support Engineer

*Please rate the Post so other will know when an answer has been found.