ANNOUNCEMENT - The community will be down for maintenace this Thursday August 13 from 12:00 AM PT to 02:00 AM PT. As a precaution save your work.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.
Get the latest news in this issue of the Cisco Small Business Monthly Newsletter

3022
Views
0
Helpful
8
Replies
Highlighted
Beginner

QoS bandwidth rate limit don't work

Hello

Buy a router RV120W, and one of the reasons is limit of bandwidth (QoS). I set up a profile of 1-256 kbps limit, and apply it to the only VLAN that is configured, but does not work and can navigate using the full bandwidth of the internet connection. My firmware version is 1.0.2.6

Screenshots attached

thanks

screenshots attached

rv120w-1.png

rv120w-2.png

rv120w-3.png

Everyone's tags (4)
1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Rising star

Re: QoS bandwidth rate limit don't work

You may need a Cisco Small Business 300 series managed switch to accomplish your scenario.

View solution in original post

8 REPLIES 8
Highlighted
Beginner

QoS bandwidth rate limit don't work

I tried with vlan, subnet, ssid and always the same, any ideas?

Highlighted
Rising star

QoS bandwidth rate limit don't work

The rate limiting is effective only when the total traffic exceeds the available WAN bandwidth.

Highlighted
Beginner

QoS bandwidth rate limit don't work

Thanks Tekliu

So how I can do to make the devices connected to RV120w may only take up to 256 kbps my internet connection?

Highlighted
Rising star

QoS bandwidth rate limit don't work

RV120W will not restrict the traffic flow when the WAN bandwidth is under-utilized. 

Highlighted
Beginner

QoS bandwidth rate limit don't work

thank you very much

Then I will try another way or another device. Know any of the small business family that can do this?

Highlighted
Rising star

Re: QoS bandwidth rate limit don't work

You may need a Cisco Small Business 300 series managed switch to accomplish your scenario.

View solution in original post

Highlighted
Beginner

QoS bandwidth rate limit don't work

Research and RV120W router does not offer this feature as I need it. However the Cisco WRVS4400N Wireless-N Gigabit Security Router - VPN v2.0 includes this function and the price is very similar. The difference is that the WRVS4400N can configure kbps up and down you want to assign to specific users without exceeding the limit.

Highlighted
Beginner

Re: QoS bandwidth rate limit don't work

Struggling with a similar issue:

the setup: internet adsl <--1mbs--> combined router/modem <--100mbs--> RV 120W

Internet speed is 1mbs. I want to priotize voip calls (via port) and deprioritize one machine (doing downloads). rest of the network should have something in between.

Firmware upgraded to 1.0.3.10

I created the profiles bindings, then in QoS settings, selected Priority, Wan total bandwidth 1mbs, and distributed my profiles onto low/med/high (10/31/61).

When what should be low is downloading, it gets the whole 1mbs and the other are dead slow.

Changed to rate limit, changed the parameters, etc... no more luck.

Can you please shed some light as how to configure this - in my case, the whole bw of wan is being used, and prioriization is not happening,

Rgds