cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.
Get the latest news in this issue of the Cisco Small Business Monthly Newsletter

985
Views
0
Helpful
2
Replies
Highlighted

QoS binding limited to IP address range and SSID on WLAN

Our VLAN id 2 is used only by a WLAN SSID

Defining a QoS profile as using VLAN id 2 did not work. No upper rate limitation worked

Only using the IP address range of the VLAN or the SSID appeared to work.

It does not appear consistent, when a VLAN id can be specified on a WLAN in the  Wireless Basic Setting Table

It is also inconsistent, that the proper SSIDs are not listed in the drop down box on the

Add / Edit Profile Binding Configuration page. They only appear as AP-1, AP-2 etc.

2 REPLIES 2
Highlighted

This is on the RV220W using firmware 1.0.3.5

Highlighted

Has this been fixed under firmware 1.0.4.17? I cannot get this work with any type of Traffic Selector (IP/MAC/VLAN/DSCP/SSID).

Any suggestions are greatly appreciated. Thanks!