04-28-2012 09:06 AM
Our VLAN id 2 is used only by a WLAN SSID
Defining a QoS profile as using VLAN id 2 did not work. No upper rate limitation worked
Only using the IP address range of the VLAN or the SSID appeared to work.
It does not appear consistent, when a VLAN id can be specified on a WLAN in the Wireless Basic Setting Table
It is also inconsistent, that the proper SSIDs are not listed in the drop down box on the
Add / Edit Profile Binding Configuration page. They only appear as AP-1, AP-2 etc.
04-28-2012 09:08 AM
This is on the RV220W using firmware 1.0.3.5
09-26-2012 08:00 PM
Has this been fixed under firmware 1.0.4.17? I cannot get this work with any type of Traffic Selector (IP/MAC/VLAN/DSCP/SSID).
Any suggestions are greatly appreciated. Thanks!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: