07-22-2019 07:09 AM
Hi,
- I have a SITE A (RV320, gateway mode, 192.168.1.0/24) connected with gateway to gateway vpn to SITE B (RV320, gateway mode, 192.168.2.0/24).
- SITE A is also connected by a static route to SITE C (other brand router, gateway mode, 192.168.3.0/24).
- I want clients on SITE B can joined clients on SITE C and vice versa.
- How can I do this (static route,...other config else vpn B-C).
Regards.
07-22-2019 12:48 PM
If SITE B and SITE C can reachable already, allow them in the intersting traffic via VPN to Site A (192.168.3.0/24 )
07-23-2019 02:44 AM
Hi,
Thank you for the reply, but how I can do this??
This is a schema of the network :
07-23-2019 04:56 AM
07-23-2019 07:46 AM
SITE C, make a Route - Static / Dynamic Routing depends on your requirement.
SITE C make static route for 192.168.1.0/24 192.168.2.0/24 towards 192.168.1.X
SITE B Route 192.168.1.0/24 192.168.2.0/24 towards SITE A Tunnel.
Make sure SITE A and SITE B allow interesting traffic for 192.168.1.0/24 2.0/24 3.0/24
07-25-2019 02:44 AM
Hi BB,
First thank you for your response.
Tested all static route possible on all nodes without success.
Other problem I note is that ping from Site A to Site B (gateway to gateway VPN link) work only for Site B gateway (192.168.2.1) not for others clients on Site B, but all clients on Site A are reacheable from Site B.
I find an article with the same probleme I think but I did not understand the solution https://community.cisco.com/t5/small-business-routers/rv320-issue-routing-between-vpns/td-p/2714568
07-25-2019 03:27 AM
07-25-2019 03:58 AM
Thank you Alkor.
But RV320 does not support GRE, is there another way to do this????
07-25-2019 04:24 AM
07-28-2019 10:06 AM
Hi,
Any idea on how to configure Flex VPN on RV320 (see screen capture).
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: