- I have a SITE A (RV320, gateway mode, 192.168.1.0/24) connected with gateway to gateway vpn to SITE B (RV320, gateway mode, 192.168.2.0/24).
- SITE A is also connected by a static route to SITE C (other brand router, gateway mode, 192.168.3.0/24).
- I want clients on SITE B can joined clients on SITE C and vice versa.
- How can I do this (static route,...other config else vpn B-C).
If SITE B and SITE C can reachable already, allow them in the intersting traffic via VPN to Site A (192.168.3.0/24 )
SITE C, make a Route - Static / Dynamic Routing depends on your requirement.
SITE C make static route for 192.168.1.0/24 192.168.2.0/24 towards 192.168.1.X
SITE B Route 192.168.1.0/24 192.168.2.0/24 towards SITE A Tunnel.
Make sure SITE A and SITE B allow interesting traffic for 192.168.1.0/24 2.0/24 3.0/24
First thank you for your response.
Tested all static route possible on all nodes without success.
Other problem I note is that ping from Site A to Site B (gateway to gateway VPN link) work only for Site B gateway (192.168.2.1) not for others clients on Site B, but all clients on Site A are reacheable from Site B.
I find an article with the same probleme I think but I did not understand the solution https://community.cisco.com/t5/small-business-routers/rv320-issue-routing-between-vpns/td-p/2714568