cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Announcement“Cisco Design Thinking Workshop”. Cisco Small Business is excited to invite its Silicon Valley customers to an exclusive interactive one-day session between customers and product Managers.  If you are interested in this exclusive workshop, please fill out the Registration Form. For more information, please check out our FAQ


Get the latest new and information the November issue of the Cisco Small Business Monthly Newsletter

488
Views
0
Helpful
4
Replies
Highlighted
Beginner

rv016 access to modem administration page in wan1, wan 2,... from LAN

Hi,

we have rv016 router installed, balancing 5 adsl conections.

We can access to rv016 router with IP 192.168.1.1 from LAN.

We can access to the modem1 administration page in wan1 that has IP 10.0.0.1

But we can't access to another modems administration pages like wan2 that has IP 10.0.0.2, or modem in wan3 with IP 10.0.0.3, modem in wan4 or modem in wan5...

In the diagnostic page of rv016, we can do a success ping to 10.0.0.1, but not to another wan...

All modems have DHCP enabled with access permission ok.

Can you help us?

Thanks!

Everyone's tags (4)
1 ACCEPTED SOLUTION

Accepted Solutions
Rising star

rv016 access to modem administration page in wan1, wan 2,... fro

Hi,

Change the modems to have LAN IP addresses in different subnets:

10.0.0.1

10.0.1.1

10.0.2.1

10.0.3.1

10.0.4.1

Then everything should work perfectly.

Please mark this thread as answered or reply if you have any additional questions.

- Marty

View solution in original post

4 REPLIES 4
Rising star

rv016 access to modem administration page in wan1, wan 2,... fro

Hi,

Change the modems to have LAN IP addresses in different subnets:

10.0.0.1

10.0.1.1

10.0.2.1

10.0.3.1

10.0.4.1

Then everything should work perfectly.

Please mark this thread as answered or reply if you have any additional questions.

- Marty

View solution in original post

Beginner

rv016 access to modem administration page in wan1, wan 2,... fro

Hi!

It works!

Thanks!

Contributor

rv016 access to modem administration page in wan1, wan 2,... fro

I used to have problems like this when accessing 3 cable modems that all had a 192.168.0.100 address.

A couple of solutions--simply refresh the page and each refresh will usually go over a different wan, hitting a different modem.

Change the IPs on the modems as suggested (probably not possible).

Or, what I would do is simply release the IP for a wan to remove it from the available wans and then the request will go over only the wan I want and hit the modem I want.  This always worked even though it was a bit cumbersome.    

Huntsville's Premiere Car and Bike e-magazine: www.huntsvillecarscene.com

Huntsville's Premiere Car and Bike e-magazine: www.huntsvillecarscene.com
Beginner

rv016 access to modem administration page in wan1, wan 2,... fro

Hi,

Thanks for your answer.

I found the solution, changing the IPs of the WANs:

10.0.1.1

10.0.2.2

10.0.3.3

10.0.4.4

10.0.5.5

Regards!