While trying to configure my RV042, I "turned on" the DMZ Host functionality (under Setup > DMZ Host) by entering the LAN IP address of one of our machines. I now believe that I don't actually want this on. According to the Help page (and also the manual) it says:
"Enter the IP address of the network device that you want to use as a DMZ host. Alternatively, enter zero (0.0.0.0) to disable the DMZ Host."
So I try to enter 0.0.0.0 as the address, and it give me an error:
What am I doing wrong? Are the instructions just incorrect? Is there a way to turn this off?
Solved! Go to Solution.
Unfortunitly I'm not sure how to confirm if DMZ Host is disabled. I mistakenly enabled it when trying to get the DMZ working, and (in a different discussion) you informed me that I didn't need to have it enabled. So I was trying to disable it, but was running into the above error. If you can tell me how to test if it's disabled I'd be happy to.
There *should* be a "disable DMZ" tick box, but since Cisco seems to have hired a monkey to put this firmware together in a short day on Christmas Eve, there is not (actually, kudos for the last update that fixed myriad critical problems), the most certain way to "disable" DMZ is to enable DMZ and point it at a nonexistent internal IP address (or even better, a honeypot, so you can log attempted attacks! ;-)
This could be a problem if you do not maintain control of your internal IPs--e.g. if you let DHCP dole them out willy nilly. You can remedy this, assuming your DHCP server is your RV042, and not some other DHCP server: Set up manual IP tables for RV042's DHCP server at
look down to
DNS Local Database
IP Address =
That should kill access to any random machine on your LAN from the Internet.