There is some information about RV042(G) PPPoe and DMZ which not documented and even not published in community forum:
How DMZ works if WAN1 configured for PPPoe (e.g. ADSL) uplink port with dynamic address, gateway and dns assigment (and WAN 2 configured for DMZ).
DMZ port got PPPoe pass trough to WAN1 uplink port?
DMZ port is behind a ppp stack?
DMZ port is behind a nat?
I think DMZ port is not behind a firewall.
How I configure DMZ port with static address if uplink wan port has dynamic address?
How I configure DMZ port with static address if uplink wan port has only one dynamic address (assined at authentication) not a all address range?
How change operation above if WAN1 configured for direct ethertnet connection with DHCP address assignment (and WAN 2 configured for DMZ)?
Anybody can explain for us. Thanks for any authentic answer.