Hi,
I have recently purchased the rv042, I have two broadband connections both PPPoA, the first has a static IP and connects with the rv042 no problem (via a Thompson 585v7 in bridge mode).
The second has a dynamic IP. I have set the Thompson 585 'modem' in to bridge mode and when I connect via Ethernet to a PC, the PC is given an external IP...ie bridge mode working correctly.
In the rv042 I set the WAN2 connection type as PPPoE, however the rv043 requires a username and password and my ISP does not use one.
When I click save setting on the rv042 the display is updated with some characters in the password field, even though I left them blank.
I have followed the full procedure from this article:
http://www.cisco.com/en/US/products/ps9923/products_qanda_item09186a0080a369fb.shtml
expect entering the username and password as there isn't one.
My ISP's settings can be seen here:
http://www.beusergroup.co.uk/technotes/index.php?title=Settings_for_other_routers
RV042 firmware version: 1.3.13.02-tm
Thompson routers both have latest firmware.
Any support with this issue would be greatly appreciated.
