I had an existing RV042 to RV042 Gateway to Gateway VPN working successfully.
The modem failed at one of the locations and it was replaced by a Comcast X-finity Gateway/Router. Unfortunately, I have no choice on this device. I am trying to get the VPN to work from the 2 locations again.
VPN Gateway-to-Gateway Configuration (no change, other than IPs)
Local - IP Only, Subnet
Remote IP Only, Subnet
Existing network configuration, no changes
Just updated the IP address for Remote Group Setting on the RV042
New modem configuration.
Enabled DMZ on new "Gateway" and put the RV042 in it, disabled all firewall rules on the gateway, and disabled any other type of filtering options I could find. I can access the RV042 port forwards remotely as it should, so I know the DMZ is working.
Systems will conenct, however no data is being passed. I did a bunch of searches and based on results tried turning on/off NAT Traversal, and Agressive Mode. Same result.
Tried initiating the connection from both RV042s. Both instances shows connected, but no data.
I have 2 theories -
1) While putting the RV042 in the gateway DMZ, it doesn't have full access. I tried doing a PPTP vpn to the unit which worked before, but will not complete the connection process now.
2) The IP address of the double NATed RV042 is 10.0.0.3. Is this throwing off the VPN connection?
Hm...there is no conflict between IPs on the LAN and WAN side...in that case I would do this:
-Take out the RV042 on Location 2 from DMZ, then put it behind NAT, turn off all firewall..
-Make configuration where one router on Location 1 has static public IP, and second router on Locaion 2 is behind firewall n this situation Remote Security Gateway Type setting on router in Location 1 should be Dynamic IP + FQDN or Dynamic IP + Email Address, and Local Security Gateway Type on router in Location 2 should be Dynamic IP + FQDN or Dynamic IP + Email Address)...
QuestionDear All,I'm currently looking for firmware version 188.8.131.52 for Linksys SPA400 Analog Telephony Gateway. Unfortunately, my device was bricked and I was able to recover it using a recovery tool and recovery firmware version 184.108.40.206 but can't find v...
Change in ASD Automatic Software Download Feature
Dec 13th, 2019
Cisco RV160, 260, 340, and 345 Series Routers
Due to an API change in Cisco’s software download platform the Automatic Download Feature (ASD) on RV series routers will be temporarily ...
SFP Module Support List for RV160x and RV260x Devices
Small form-factor pluggable (SFP) ports are included on the RV160 and 260 routers to allow the use of optical SFP transceiver modules. SFP’s convert the optical signals to electrical signals. SFP’s al...
Welcome and thanks for visiting the Small Business Community Newsletter. This is our first of what we will make a monthly newsletter where you will be provided information on New products and trends, What’s ...