RV042G Dual WAN IP Filtering

[sebjavierw]

I have a Cisco RV042 setup with Dual WAN Load Balance.

I am wondering if there is some way I could limit certain computers (IP Addresses) to only use one WAN (either WAN1 or WAN2).

I am having a few problems logging in and using CPanel services.

I am continuing being logged out and because of two IP addresses being used for logging etc.

I hope someone has had this issue or someone knows how to fix this.

Thankyou any help will be appreciated

[Michael Vandergrift]

Hello sebjavierw,

You should be able to use the Protocol Binding feature of the RV042 to accomplish your goal.  Go to System Management > Dual WAN > WAN1 Configuration > Protocol Binding to specify which IP source and destination addresses use each WAN interface.  

Regards,

Mike

[sebjavierw]

Hi

Thankyou for your help in replying.

I'm sorry but I forgot to mention that my router is the RV042G.

I have looked for the Protocol Binding option but I cannot seem to find it anywhere. I am assuming that it is not available for the RV042G.

Is there anyway I can achieve the same goal through Firewall Access Rules?

Thankyou

[mpyhala]

sebjavierw,

The RV042G has the same feature set as the RV042. Protocol Binding can be found under Load Balancing.

http://www.cisco.com/c/dam/en/us/td/docs/routers/csbr/rv0xx/administration/guide/rv0xx_AG_78-19576.pdf

- Marty

[Michael Vandergrift]

Hey,

Attached are some screenshots that you might find helpful.

Mike