I'll try my best to explani and give details.
SA540 v.2.1.71 at host
RV082 v4.2.1.02 at remote site.
Trying to setup tunnel between the 2. WHEN this works, I'll have 20 remote sites tunneling into the SA540 host.
SA540:
SA540 says site to site vpn is up and IPsec SA Established.
192.168.1.0
| Gateway Policies | Client Policies | |
| Exchange Mode: | Main | Aggressive |
| ID Type: | Local WAN IP | FQDN |
| Local WAN ID: | Local WAN IP | local.com |
| Remote WAN ID: | N/A | remote.com |
| Encryption Algorithm: | AES-128 | AES-128 |
| Authentication Algorithm: | SHA-1 | SHA-1 |
| Authentication Method: | Pre-shared Key | Pre-shared Key |
| Key-Group: | DH-Group 2 (1024 bit) | DH-Group 2 (1024 bit) |
| Life Time: | 8 hours | 8 hours |
VPN Wizard default values for VPN:
 | | |
| Encryption Algorithm: | AES-128 | |
| Authentication Algorithm: | SHA-1 | |
| Life Time: | 1 hour | |
| PFS Key Group: | DH-Group 2(1024 bit) | |
| NETBIOS: | Enabled (Gateway Policies) | |
| Disabled (Client Policies) |
WAN Security Checks
| | |
| Block Ping to WAN interface | ||
| Enable Stealth Mode | ||
| Block TCP flood |
RV082:
RV082 says gateway to gateway is Connected.
192.168.2.0
same settings w/ Aggressive, Keep Alive and NAT Traversal checked.
Firewall Setting Status
| SPI (Stateful Packet Inspection) : | On |
| DoS (Denial of Service) : | On |
| Block WAN Request : | Off |
| Remote Management : | On |
FROM RV082 diagnostics on router, I cannot ping 192.168.1.1 router or 192.168.1.70 server inside host.
FROM SA540 host diagnostics, I CAN ping 192.168.2.1 when I check Ping through VPN tunnel, but I canNOT ping an XP computer at 192.168.2.100 which has firewall turned off.
What am I missing?
Goal is to establish full tunneling and computer/server access between sites.
Any help is greatly appreciated.
