cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.

962
Views
0
Helpful
1
Replies
itsupport
Beginner

RV110W- Apply Access Rules

I have an issue with Single Port Forwarding on these units.

I wanted to try Access Rules as a workaround.

When I set an Access Rule for, let's say, HTTP and point it to an internal IP, when I try browse to the address, I get the router maanagement page instead. This puzzles me as the router is a different IP, and does not have HTTP enabled for management.

If I set an Access Rule for FTP, the connection attempt is blocked.

So, anyone using Access Rules for inbound traffic? Is it possible? How are you configured?

Thanks

1 REPLY 1
jasbryan
Frequent Contributor

Please contact the Cisco Small Business Support Center and open a support case with next available engineer @ 1-866-606-1866

Jasbryan