cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
746
Views
0
Helpful
2
Replies

RV130 access rules do not work after i upgrade firmware

wborja704
Level 1
Level 1

I had a RV130  and I set up two access rules on that block all IP's (WAN =>LAN) and the other one that allow jus a specific IP .

after I did the firmware update (1.0.1.3 =>1.0.1.14)I block all the IP's and doesn't let me telnet to the IP that allow  all the traffic ...

2 Replies 2

Luis Gradyz
Cisco Employee
Cisco Employee

Hello 

Thanks for the response the router was running on 1.0.1.3 and it was fine but after I upgrade to 1.0.1.14 the router block all incoming traffic

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: