05-07-2015 04:35 PM
Is it possible to route 2 vlans across a VPN link between 2 rv130's Say 192.168.1.0 to 172.16.1.0 And 192.168.2.0 to 172.16.2.0?
05-12-2015 05:54 AM
Hi - you should be able to create one IKE policy between the 2 routers and then create 2 VPN policies for each local/remote subnet. Just associate both VPN policies to the same IKE policy.
Create IKE Policy for VPN connection between the 2 routers.
VPN Policy 1 - 192.168.1.0 to 172.16.1.0 - associate to IKE Policy
VPN Policy 2 - 192.168.2.0 to 172.16.2.0 - associate to same IKE policy
Hope this helps.
01-14-2016 01:28 AM
This unfortunately doesn't work.
The aim is to transport data between more than 1 Subnet on each side via one VPN-Connecten.
But if you add a second VPN Policy pointing to the same external IP of the remote VPN-Server you got the error message "Rule already exists."
I also tried to add the second VPN connection via "Basic VPN Setup". This added a new IKE Policy and an new VPN Policy with the second subnet pair with default VPN parameters. But when I edit the new VPN Policy to correct some parameters and want to save the changes I get the above error again.
So i think its a bug in this firmware release (1.0.2.7).
The "trick" with a second policy associate to the same IKE policy worked on older SA500 and ISA500.
So is there any solution for this problem? Otherwise the VPN functionality of this VPN-router is quite poor.
Thanks and Best Regards,
Woger
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: