cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
554
Views
0
Helpful
1
Replies

RV180W firmware 1.0.2.6 UC 100%

datak2011
Level 1
Level 1

Hi,

i've installed the new firmware on my router and now the UC is showing 100% all the time

I've tried to factory reset it, it's doing the same thing

If I downgrade to previous firmware, it goes back to normal

I've only 1 PC in my network (test lab), so no big traffic here.

is it a bug ?

1 Reply 1

jonatrod
Level 7
Level 7

Good morning

Hi Tommy, thanks for using our forum, my name is Johnnatan and I am part of the Small business Support community. Can you please reach out to our Small Business Support Center and open a Service Request to address this issue to confirm if this is a bug? One of our Engineers may be able to work with you and diagnose the root cause. You can find the appropriate contact information for SBSC in the below link.

http://www.cisco.com/en/US/support/tsd_cisco_small_business_support_center_contacts.html

I hope you find this answer useful,

*Please mark the question as Answered or rate it so other users can benefit from it*

Greetings,

Johnnatan Rodriguez Miranda.

Cisco Network Support Engineer.

“Please rate useful posts so other users can benefit from it” Greetings, Johnnatan Rodriguez Miranda. Cisco Network Support Engineer.
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: