RV180W firmware 1.0.2.6 UC 100%

[datak2011]

Hi,

i've installed the new firmware on my router and now the UC is showing 100% all the time

I've tried to factory reset it, it's doing the same thing

If I downgrade to previous firmware, it goes back to normal

I've only 1 PC in my network (test lab), so no big traffic here.

is it a bug ?

[jonatrod]

Good morning

Hi Tommy, thanks for using our forum, my name is Johnnatan and I am part of the Small business Support community. Can you please reach out to our Small Business Support Center and open a Service Request to address this issue to confirm if this is a bug? One of our Engineers may be able to work with you and diagnose the root cause. You can find the appropriate contact information for SBSC in the below link.

http://www.cisco.com/en/US/support/tsd_cisco_small_business_support_center_contacts.html

I hope you find this answer useful,

*Please mark the question as Answered or rate it so other users can benefit from it*

Greetings,

Johnnatan Rodriguez Miranda.

Cisco Network Support Engineer.