09-05-2012 06:41 PM
Hello,
I am setting up a customer site. One side is RV180W and the other side is Checkpoint 500W.
RV180W side
LAN - 192.168.100.0/24
Checkpoint side
LAN - 172.26.1.0/24
VOIP - 172.26.2.0/24
Need to setup an ipsec tunnel between the site. However, from the RV180W side, I can only ping the VOIP network, but not LAN. Need help. I have heard that RV180W only can talk to one remote network via ipsec, correct? Any other way to workaround this other than changing out the RV180W? Thanks.
Ho
09-05-2012 06:51 PM
Hi Eit, make a second VPN connection to the LAN connection of the checkpoint.
-Tom
Please rate helpful posts
09-05-2012 07:12 PM
Thomas,
With the same public ip on both ends? Thanks.
Ho
09-05-2012 07:15 PM
Correct, everything the same except change the remote LAN to match the subnet desired, in your case 172.16.1.0
-Tom
Please rate helpful posts
11-14-2012 01:52 PM
Hi Tom,
I have a similar situation, needing to setup 3 tunnels to the same endpoint. Each tunnel has a different remote LAN setting, but I can only get one tunnel to work at a time. I have to disable the other two. For more details, see my posting: https://supportforums.cisco.com/message/3781143#3781143
How can I setup 3 IPSEC tunnels to the same endpoint?
Marshall
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: