RV180W worthless with current firmware?

[bob]

Having just installed a new RV180W router for a customer last week, I am beginning to regret my decision to to go with this model. Issues are as follows:

1. Users connecting via VPN can not browse web or receive email until the disconnect from the VPN.

2. Internal users experiencing very slow web site access and page lockups (speed test shows a good 15MB connection rate)

3. No clear setup for an isolated 'guest' WiFi network.

All of this happened as soon as I replaced the old, stable RV042 with the new RV180W.           

[jonatrod]

Good morning

Hi Bob, thanks for using our forum, my name is Johnnatan and I am part of the Small business Support community. Fist at all I apologize for the issues you are having, in order to help you I was wondering if could you tell us a little more about  your problem, for example:

What kind of VPN are you configuring? Are you using IPsec?

What is MTU size of your device for the connections?

Could you share with us some screenshot of your Wifi configuration?

Did you isolate both, vlan and Wifi?

Ensure you are running the firmware 1.0.1.9

Thank you and again I apologize for the issues you are having.

Greetings,

Johnnatan Rodriguez Miranda.

Cisco Network Support Engineer.