RV215W inbound rules with control ip

[seleva_cisco]

Hello,

I have a  Cisco RV215W and i want to create inbound rule (wan -> lan) with ip control.

I ha created in "service management" a new service (rsync on 873 start port and and port)

After i had created a new access rules :

Action : Always Allow

Service : Rsync ( a service created in service management)

Status : enable

Connection type : inbound (Wan -> Lan)

source ip : single ip with outdoor serveur

Destination ip : ip to NAS

When i connected on outdoor server, i used telnet :

telnet my_public_ip 873      and i cannot connect my NAS

when i create a rule in "single port forwarding", my outdoor server can access on my NAS (but all outdoor customer can access on my NAS....)

Do you have an idea?

thank a lot per advance

[jonatrod]

Hi Bruno, thank you for using our forum, my name is Johnnatan I am part of the Small business Support community. You could create an ACL to allow the specific address to the NAS and deny the rest.

Bellow I will share a Link with a document regarding ACL,

http://www6.nohold.net/CiscoSB/Loginr.aspx?login=1&pid=2&app=search&vw=1&articleid=3707

http://www6.nohold.net/CiscoSB/Loginr.aspx?login=1&pid=2&app=search&vw=1&articleid=3707I hope you find this answer useful

“Please rate useful posts so other users can benefit from it”

Greetings, 
Johnnatan Rodriguez Miranda.
Cisco Network Support Engineer.

[seleva_cisco]

Hello Jonathan,

Thank's a lot for your response.

I have read your link and my configuration it was same your link except a rule to deny the rest.

but when i try a connection i receive an error :

it's very strange...

If i put my NAS in dmz all is ok...

And my firmware is a 1.1.0.5

Best regards