cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.

480
Views
0
Helpful
1
Replies
Joergen Thomsen
Beginner

RV220W 1.0.2.4: 6to4 Tunnel did not initialize after reboot

IPv6 -> Tunneling

The 6to4 tunnel did not initialize after a reboot.

The automatic tunneling had to be disabled and enabled again.

It was used for a 6in4 tunnel to tunnelbroker and the Remote End Point IPv4

Address was enabled and specified.

1 REPLY 1
Joergen Thomsen
Beginner

Why is this bad ?

After a power outage or deliberate power cycling the unit, the IPv6 network is not working.

What does this mean for Cisco? No sale.

I do not replace our current branch office router with this unit yet.

When managing the site remotely it has been invaluable, that the current router has been able to provide access through IPv6 when there was certain problems with IPv4.

The issue has been reproduced.