05-17-2012 08:24 AM
I have successfully build my tunnel, but I cannot seem to get traffic to flow across it to the corporate network on the other side of the tunnel. Is it necessary to create any routing information so that work flows?
05-17-2012 11:23 AM
Traffic will still have to be routed just like a standard WAN link. Static routes or a dynamic protocol must be used to route your traffic accross the tunnel.
Regards,
Tom
05-17-2012 12:55 PM
It's not needed to add additional routes if the traffic is between the two subnets defined in the VPN policy.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: