cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1610
Views
0
Helpful
3
Replies

RV220W Firmware Update fails (RV220W-Firmware-1.0.2.4.img)

indizas_cisco
Beginner
Beginner

I've previously upgraded the firmware on our RV220W from 1.0.0.26 to 1.0.1.0 without any problems but all attempts to upgrade to the latest version 1.0.2.4 fails with the following message "Upgrade failed due to invalid/corrupted firmware". The router then automatically reboots with the current firmware.

We've already tried re-downloading and applying the update from several different machines using different operating systems and browsers without success. Has anyone else managed to apply this firmware version successfully? We really need one of the VLAN fixes included in this latest version!

Any suggestions would be much appreciated.

1 Accepted Solution

Accepted Solutions

linksysinfo
Enthusiast
Enthusiast

have you tried reseting the router back to factory defaults?

coming from 1.0.2.6 requires a factory reset once you have upgraded to 1.0.1.0 so perhaps this still needs a reset?

Regards Simon

View solution in original post

3 Replies 3

linksysinfo
Enthusiast
Enthusiast

have you tried reseting the router back to factory defaults?

coming from 1.0.2.6 requires a factory reset once you have upgraded to 1.0.1.0 so perhaps this still needs a reset?

Regards Simon

Much appreciated!!!

I didn't realise a factory reset is required after each firmware upgrade.

Sent from Cisco Technical Support iPhone App