cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.
Get the latest news in this issue of the Cisco Small Business Monthly Newsletter

896
Views
0
Helpful
2
Replies
Highlighted
Beginner

RV220W VLAN to VPN traffic

Hello,

Just setup two RV220Ws with a IPsec VPN connection.  All working well.  However, I have a question regarding how to force ALL traffic from a VLAN to go thru the VPN.

IPsec from site A (EU) to site B (USA) working good.  On Site A I have a dedicated VLAN that needs to have ALL traffic (internet included) be sent thru the VPN tunnel.  The main purpose of this is to have internet presence as if in the USA.  This is necessary to access some sites available only in USA specially for the kids -their web sites will not display content because they're not in the USA at the moment.  How do I accomplish this?   I tried to setup a Static Route for the VLAN but you cannot setup a 0.0.0.0 destination route.

Any help would be greatly appreciate it.

Regards,

Jose

2 REPLIES 2
Highlighted
Advocate

Hi Jose, I could be mistaken but I do not think the RV220W supports full tunnel site to site VPN.

I do know the SSL VPN can be full tunnel.

-Tom
Please rate helpful posts

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/
Highlighted

Hi Tom,

I was under the impression that the RV220W does support full tunnel but then again I might be mistaken.  I have not used the SSL VPN yet but I will give it a try.

Thanks,

Jose