cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.
Get the latest news in this issue of the Cisco Small Business Monthly Newsletter

478
Views
0
Helpful
1
Replies
Highlighted
Beginner

RV260 router configuration

Hi all.

I have a new RV260 router running on 1.0.00.16 system image.

In short. First thing I need to do is connecting to a serial console of the device. I connected my device via the serial port on 115200,8, N,1. I think my settings are correct because I see the booting process on my console. After a successful boot, I can manage my device via the web interface, but the serial console does not respond. No reaction to my input.

I am trying to use the console in order to setup subinterfaces. That is the second thing. According to the documentation, it is possible.

"

Cisco IOS software supports four types of virtual interfaces;
•loopback
•null
•subinterface
•tunnel

"

But for now, I am not sure if this (setting up subinterfaces) is possible at all on this router.

1 REPLY 1
Highlighted
Beginner

Hi Yaro,

 

I read in another post here that the CLI in RV260 is not enabled yet. This was from a Cisco employee and another poster.

 

HTH.