cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
422
Views
0
Helpful
8
Replies

RV325 Static IP Not Working

jenius
Beginner
Beginner

After a factory reset, static IP settings won't fully load websites. Was working fine before reset. Connected laptop and several routers with the static settings and web works fine. Turned off "Enable Network Service Detection" under System Management | Dual WAN. The browser bar loads about 25% then freezes and won't proceed. Is there anything else that needs to be configured for static IP to work? I'm on latest firmware...

2 Accepted Solutions

Accepted Solutions

marce1000
VIP Mentor VIP Mentor
VIP Mentor

 

  - Check logs on the RV.

 M.

View solution in original post

balaji.bandi
VIP Community Legend VIP Community Legend
VIP Community Legend

Remove the WAN Connection from Router. reload the Device - check is the Router can access web GUI as expected.?

there were some exploits on these models, so check no outside connection allowed for web GUI and https access. remote management make it Lan IP range.

then connect to WAN and check, do you have dual WAN connection or one ISP ?

 

 

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

View solution in original post

8 Replies 8

marce1000
VIP Mentor VIP Mentor
VIP Mentor

 

  - Check logs on the RV.

 M.

It’s showing that the connection is up and then it fails.

Got a new static IP from ISP and all is well. Thanks for your help.

balaji.bandi
VIP Community Legend VIP Community Legend
VIP Community Legend

Remove the WAN Connection from Router. reload the Device - check is the Router can access web GUI as expected.?

there were some exploits on these models, so check no outside connection allowed for web GUI and https access. remote management make it Lan IP range.

then connect to WAN and check, do you have dual WAN connection or one ISP ?

 

 

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

One ISP

balaji.bandi
VIP Community Legend VIP Community Legend
VIP Community Legend

Remove ISP connection and see you able to access the GUI

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

I do…

Got a new static IP from ISP and all is well. Thanks for your help.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers