RV340 First connection

[josefuentes599130302]

Hey, I'm new in the world of cisco routers, I just bought a 2nd handed RV340 for load balancing and VPN, I connected my ISP provider to WAN 1 port and my PC to any LAN port to start the basic configuration, but my PC doesn't receive a DHCP IP from the RV340, I just receive a random IP, I tried factory reset with no good results.

Any suggestions of what can I do?

[chesterr]

Hello,

Could you show running-config of RV340 ?

[balaji.bandi · Accepted solution]

basically these device do not have any Cli access to post show run.

Steps :

1. reset to factory

RESET—Reboot or reboot and restore defaults:

• To reboot the unit and retain the current configuration, press and hold

RESET for at least 3, but no more than 10 seconds, by using a paper clip

or a pen tip.

• To reboot the unit and restore the factory default settings, press and

hold in the RESET button for more than 10 seconds. Changes made to

the original configuration of your device are lost.

2. then do the quick setup :

https://www.cisco.com/c/dam/en/us/td/docs/routers/csbr/RV340/Quick_start/EN/rv340_qsg_en.pdf

[josefuentes599130302]

Hey! I tried many times to do the factory reset, but no good results, then I thought it might need more time than 10 seconds, I leave the button pressed until the VPN Led turned red, unplug and plug the power and it worked! I am now able to access my RV340 GUI.