cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Please be advised, the GuideMe Wizard is no longer available on the Small Business Support Community. For search capability please use the community search field to find content related to Cisco Small Business documents, videos, and discussions.
224
Views
0
Helpful
0
Replies
Highlighted
Beginner

RV340 to AWS Site-to-Site VPN with Dual IPSec Tunnels

Hello,

AWS Site-to-Site VPNs typically provide two separate IPSec tunnels for redundancy (see diagram https://docs.aws.amazon.com/vpn/latest/s2svpn/VPNTunnels.html). Typically, an office router will be configured to connect to _both_ of these tunnels to prevent downtime in the event that 1 tunnel drops.

 

I was wondering if anyone had successfully configured an RV340 to use this dual-tunnel configuration with an AWS Site-to-Site VPN? I have tried:

 * Configuring 2 Site-to-Site VPNs on the RV340, with the same Local/Remote Group that select traffic from the office router -> AWS VPC. When both VPNs are activated, traffic stops flowing.

 * Configured 2 Site-to-Site VPNs using the "Inside IP Addresses" from AWS as the Local/Remote Group (169.254.x.x), and adding a Static Route to direct traffic at the tunnel. Traffic does not seem to be routed properly.

 

Does anyone have notes on how they have successfully configured an AWS Site-to-Site VPN using both tunnels with an RV340?

Thank you!

Everyone's tags (4)