Hi,
I have seen this asked before, but I have never seen a concrete answer to it. My RVS4000 stops working after approximately 10-12 hrs. The web interface does not respond, no dhcp either. All statically assigned IP address devices on the network still continue to work though. The firmware is
V1.3.3.5 which is the highest as its V1.
Connected to it are
4 * SLM2008 firmware=2.0.0.10
1 * SD2008
1 * SD2005
2 * WAP200 firmware=2.0.6.0
1 * Hiltron CGN2-ROG (Rogers)
What is the best way to troubleshoot why it gets into this state? Are there known solutions to this issue?
I am unable to isolate this down to a specific switch\device as the the time it take to reproduce takes way too long.
Thanks very much.
