cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.

612
Views
0
Helpful
2
Replies
scfeigin1
Beginner

Should RV016 VPN's connect when router is turned on?

When my RV016 is restarted (for instance after a power failure) the gateway to gateway VPNs do not connect.  I have to go the router's VPN summary page and click on connect to get them started.  Is there any way for that to happen automatically?

1 ACCEPTED SOLUTION

Accepted Solutions
Te-Kai Liu
Rising star

In the advanced section of the tunnel configuration, if the DPD and Keep Alive options are checked, RV016 will try to reconnect automatically.

View solution in original post

2 REPLIES 2
Te-Kai Liu
Rising star

In the advanced section of the tunnel configuration, if the DPD and Keep Alive options are checked, RV016 will try to reconnect automatically.

View solution in original post

Thanks for the quick answer.   That solved my problem.  I have VPN's connecting 4 different routers from various companies, and I think the RV016 was the easiest to set up.  This was the only problem.  I think that the keep-alive and DPD settings are important enough to be on the main VPN setup page, not the advanced page.  I didn't even look at the advanced page because the VPN setup was so easy.