snmp table for a rv220w router

[jamesgaver]

I am looking for an snmp table for a rv220w router. I would like to reference some of the items using networx but would like to know the definitions of the items. specifically WAN traffic. eth1? what are all the others?                  

[jeffrrod]

Dear James,

Thank you for reaching the Small Business Support Community.

Please refer to the admin guide, page 144, chapter 7, for SNMP configuration setting instructions on the RV220W router;

http://www.cisco.com/en/US/docs/routers/csbr/rv220w/administration/guide/rv220w_admin_v1.0.1.0.pdf

Below is a link with the RV220W datasheet in case you'd like to know about all the different features and capabilities of this device where on the admin guide you can find configuration steps and additional information;

http://www.cisco.com/en/US/prod/collateral/routers/ps9923/ps11025/data_sheet_c78-630461.pdf

If you are looking for definitions on the networking terms and usage I suggest you to check on the Cisco Networking Academy options, besides search engines online;

https://www.netacad.com/

Please let me know if there is any further assistance we may help you with.

Kind regards,

Jeffrey Rodriguez S. .:|:.:|:.
Cisco Customer Support Engineer

*Please rate the Post so other will know when an answer has been found.

[jamesgaver]

I figured out how to configure but what I am looking for is a definition of the avalable table items like

lo

ifb0

ifb1

sit0

eth0

eth1

eth2

I assume eth1 is Wan traffic but I would like to know what each is so I can properly monitor them.