I am configuring a SR-520 with PPP with NAT. I am typing the following command that was giving from a cisco support agent but still I can not connect with the ISP. What I am missing.
Int fa0
ip add x.x.x.x y.y.y.
ip nat inside
no sh
int ethernet 0
no ip add
pppoe-enable
pppoe-client- dial-pool-number 1
int dialer 1
ip add negotiated
ip mtu 1492
encapsulation ppp
ip nat outside
no ip mroute-cache
dialer-pool 1
dialer-group 1
ppp authentication chap callin
ppp chap hostname <username>
ppp chap password <password>
ip nat inside source list 1 interface dialer 1 overload
ip classless
ip route 0.0.0.0 0.0.0.0 dialer 1