cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.

664
Views
0
Helpful
1
Replies
bartheyse72
Beginner

SRP527W Site-to-Site VPN not hiding internal addresses

Hi,

We recently purchased an SRP527W router because of its capability to configure site-site VPN tunnels. The configuration of IKE and IPSEC is working and the tunnel comes up but the problem is that the router is passing our internal IP addresses through the tunnel. The remote end we are connecting to requires us to hide all traffic behind one IP address which would ideally be our external static IP address from our ISP.

So far we have been unable to find out how to do this. Any help is appreciated.

1 REPLY 1
Andrew Hickman
Cisco Employee

Hi Bart,

I can't think of any way that the SRP500 could do what what you describe here.

Regards,

Andy