cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.

686
Views
0
Helpful
0
Replies
singh1227
Beginner

SRP527W Site To Site VPN

Hi There,

I am trying to setup site-to site VPN with SRP527W firmwar (1.02)

Example:

Site A - IP Address - 192.168.1.x /24

Site B - IP Address - 192.168.2.v .24

VPN Status Showing connected. Routing table showing ipsec0 interface for remote location traffic. I can ping the remote site gateway(192.168.1.254 from 192.168.2.x range but can't ping or connect to PC connected in 192.168.1.x). I have downgraded firmware to 1.01.27 and then to 1.01.23 but no difference.

As far as i am aware, i don't need to configure any NAT or static route when VPN tunnel is up but is it something that i am doing worng?? Please help...!!

0 REPLIES 0